-8%

Magnizon-Pure Sine Wave Inverter 48vdc 230v, 50/60hz, 6000w – Aps-6048sw-Lcd

Original price was: KSh190,000.Current price is: KSh175,200. Exc. VAT

48V DC or 230V AC input; 230V, 50 Hz output (hardwired)
6000 watts continuous output, 12000 watts peak output
Microprocessor-controlled Smart-UPS & Solar operational mode
4-Step Progressive Charging & 7-Battery Type Selector
Fully compatible with Solar/Wind solutions for Hybrid configuration
Pure sine wave output with large LCD display
High Efficiency Using Line-Interactive Circuit Topology(Full Bridge Topology)

Category: Solar Inverters

Magnizon

Description

Magnizon-Pure Sine Wave Inverter 48vdc 230v, 50/60hz, 6000w – Aps-6048sw-Lcd

Provide Pure Sine Wave power for all your alternative energy needs with the Magnizon APS-6048SW-LCD. This inverter/charger supplies 6000 watts of continuous 230V /50Hz AC power.

Reliable large pure copper-based transformer design and frequency-controlled power, very much compatible with all varieties of loads: resistive loads such as refrigerators, motors, pumps, compressors, and laser printers as well as electronic loads like TVs, Computers, power tools, and battery chargers.

Smart microcontroller-based 3-stage charging system properly charges and maintains battery bank. The charge rate is selectable so you can use a variety of battery sizes and types to fit your backup time requirements

Key Features

48V DC or 230V AC input; 230V, 50 Hz output (hardwired)
6000 watts continuous output, 12000 watts peak output
Microprocessor-controlled Smart-UPS & Solar operational mode
4-Step Progressive Charging & 7-Battery Type Selector
Fully compatible with Solar/Wind solutions for Hybrid configuration
Pure sine wave output with large LCD display
High Efficiency Using Line-Interactive Circuit Topology(Full Bridge Topology)
Quiet, high-efficiency operation, high surge capacity, and low idle current
CE Safety

Applications

Well designed for hybrid applications where solar/wind energy systems are connected along with grid or generator sets without using any relay and control mechanism.
Versatile inverter/charger with pure sine wave system with seamless transfer switching serves as an automotive inverter for RVs, trucks, and standalone alternative power source with high-end backup times with various battery technologies(VRLA, GEL, Deep cycle, Ni-Cd, and many more)
Off-grid and On-grid applications.
Telecom and ATM applications.
Remote closets and small computer room applications.
Petrochemical application
Critical applications where higher reliability is needed
Medical & lifesaving equipment
SMB requirements

Product Specifications

INPUT AC

Input Wave Form	Sine wave (Utility or Generator)
Nominal Voltage	230V AC
Low Voltage Trip	154V +/- 4%
Low Voltage Re-engage	164V +/- 4%
High Voltage Trip	253V +/- 4%
High Voltage Re-engage	243V +/- 4%
Max Input AC Voltage	270V
Nominal Input Frequency	50Hz or 60Hz (Auto detect)
Low-frequency trip	47Hz for 50Hz, 57Hz for 60Hz
High-frequency trip	55Hz for 50Hz, 65Hz for 60Hz
Output Waveform(bypass mode)	Same as Input
Overload protection	Circuit breaker
Short circuit protection	Circuit breaker
Efficiency online transfer mode	95%
Line transfer time	10 mSec Typical
Bypass without Battery connected	Yes
Max bypass current	45Amp

INVERTER SPECIFICATION/ OUTPUT

Output Waveform	Pure Sine wave
Output continuous power in Watts	6000
Output continuous power in VA	6000
Power Factor	1
Nominal Output Voltage RMS	230V AC (L-N)
Output Voltage regulation	+/-10% rms
Output frequency	50Hz +/-0.3Hz or 60Hz+/-0.3Hz
Nominal Efficiency	>88%
Surge rating	18000
Short circuit protection	Yes, fault after 10sec

INVERTER SPECIFICATION/ INPUT

Nominal Input Voltage DC	48V
Minimum start voltage DC	40V
Low battery Alarm	42V
Low battery trip	40V
High Voltage Alarm	64V
Power Saver	Below 25Watts when enabled
Power Saver	The same switched On/Off remote
Input connection type	Terminal block with secure enclosure

CHARGER MODE SPECIFICATION

AC input Voltage Range	164-253V AC
Output Voltage (DC)	Depends on battery type
Battery Charge Current	50Amp
Battery initial Voltage for start-up	0-62.8V DC
Overcharge protection shutdown	62.8V DC
Battery Type (Boost Voltage)	14.00
Gel USA (Boost Voltage)	14.10
AGM.1 (Boost Voltage)	14.60
AGM.2 (Boost Voltage)	14.40
Sealed Lead acid (Boost Voltage)	14.40
Gel Euro (Boost Voltage)	14.80
Open Lead acid (Boost Voltage)	15.10
Gel USA (Float Voltage)	13.70
AGM.1 (Float Voltage)	13.40
AGM.2 (Float Voltage)	13.70
Sealed Lead acid (Float Voltage)	13.60
Gel Euro (Float Voltage)	13.80
Open Lead acid (Float Voltage)	13.30
Calcium (Float Voltage)	13.60
De-sulphation	15.5 for 4hrs (per battery)
Remote control/RS232/USB	Yes. Optional
Size (in mm)	218x117x600
Weight	44kgs
Warranty	2 Year limited warranty Extendable up to 4 years
Safety	EMC/CE/ROHS/ISO9001

CERTIFICATION / CONFORMITY

Disturbance at Mains Terminals	EN61000-6-3:2007+ A1: 2011+ AC:2012
Radiated Disturbance	EN61000-6-3:2007+ A1: 2011+ AC:2012
Harmonic Current Emission	EN61000-3-12: 2011
Voltage fluctuations & flickering	EN61000-3-11: 2000
Electrostatic Discharge (ESD)	IEC 6100-4-2:2008
Radio-frequency & continued radiated disturbances	IEC 6100-4-3:2006 + A1:2007 + A2:2010
EFT/B Immunity	IEC 6100-4-4:2012
Surge immunity	IEC 6100-4-5:2014
Conducted RF immunity	IEC 6100-4-6:2013
Power frequency magnetic field	IEC 6100-4-8:2009
Voltage DIP	>95% reduction, IEC 6100-4-11:2004
Voltage DIP	>30% reduction, IEC 6100-4-11:2004
Voltage Interruption	IEC 6100-4-11:2004